Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento página 50

In Teranex 3D, Dolby metadata may be derived from incoming Dolby audio, if a Dolby decoder
is installed, and may also be input as serial data via the 9-pin Dolby metadata connector on the
rear of the Teranex 3D. You may also generate your own metadata in the Teranex 3D by using
one of the two commonly used configurations provided in the 'dolby metadata' menu, 'stereo'
and '5.1'. See the configurations assigned by each in the table below. The variations between
the two configurations are shown by bold text.
Video Main Menu
Audio
Noise
Reduction
Ancillary
Data
Main Menu>Audio
The 'dolby metadata' menu provides for:
‚ Pass-Thru
If your Teranex 3D also contains a 'dolby decoder' module, any metadata derived from
the decoded Dolby stream will be reinserted in the Dolby encoded output.
‚ External
To add metadata from an external metadata generator to your Dolby encoded output,
connect the generator to the '9 pin dolby metdata' connector on the rear panel.
‚ Stereo
Pre-configured metadata for stereo output.
‚ 5.1
Pre-configured metadata for 5.1 encoding, typically used with Dolby digital encoding.
Metadata Parameter
Program Configuration
Program Description Text
Frame Rate
Bitstream Mode
Channel Mode
Center Downmix Level
Surround Downmix Level
Dolby Surround Mode
LFE Channel
Dialogue Normalization
Audio Production Information
Mix Level
Room Type
Copyright Bit
System Output
Audio
Setup Mapping
Output Audio
Gain
Options
Audio
Delay
Setup
Audio Menu>Dolby Metadata
Stereo
4x2
Not programmed
Set by Conversion
Complete Main
2/0 L/R
-3 dB
-3 dB
Not Indicated
LFE Off
27
No
0
Not Indicated
Yes
Dolby Dolby Dolby Metadata
Encode Metadata
Pass-Thru
Dolby
Metadata
External
Stereo
5.1
Dolby Metadata Menu
5.1
5.1+2
Not programmed
Set by Conversion
Complete Main
3/2 L,C,R,Ls,Rs
-3 dB
-3 dB
Not Indicated
LFE On
27
No
0
Not Indicated
Yes
Teranex Processor Settings 50 50