Test Pattern - Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento

Teranex Device
Command
Model name:
Software Version:
FPGA Version:
Panel lock:
Remote lock:

Test Pattern

Command
Output:
No signal:
Test tone:
Motion:
Horizontal rate:
Variable Aspect Ratio
The Variable Aspect Ratio block performs the functions of the ADJ menu in the Teranex LCD menu.
Ranges for these numeric values are defined by the current output video format. Horizontal values
are expressed in pixels; vertical values are in lines.
The Variable Aspect Ratio commands ending in "left" will affect the conventional 2D outputs of the
Teranex AV, Teranex Express, Teranex 2D and Teranex 3D, while the "right" commands perform no
operation. When these commands are used in a Teranex 3D set to 3DModeConvert or
3DMode2Dto3D, the "left" commands will affect the Left Eye output, while the "right" commands will
affect the Right Eye output.
Command Description
Display the Teranex model name.
Display the checksum of the installed software release.
Display the FPGA version of the installed software release.
Remotely lock the front panel of the device, preventing local
operation. Values are: true (locks the panel), false (unlocks the
panel).
Manage remote connections to the Teranex processor. When
locked, the Teranex Setup utility cannot access the device via
Ethernet; however, a Telnet connection is permitted. Values are:
true (locks the device), false (unlocks the device).
Command Description
Enable video output Test Pattern. Values are: None, Black,
SMPTEBars, Bars, Multiburst, Grid
Define whether Black or Colorbars will be output when there is a
loss of input video. Values are Black, Bars
This command enables and sets the frequency for the audio test
tone in the Teranex AV only. This command is only valid when a
video test pattern is enabled. Values are: None, Tone750Hz,
Tone1500Hz, Tone3KHz, Tone6KHz
For Teranex AV only. Enable test pattern motion.
True = ON;
False = OFF
For Teranex AV only. Set motion direction and rate.
0 = no motion (default)
Range is -3 to 3, where:
Positive values = left to right motion
Negative values = right to left motion
Informations pour les développeurs 356 356