Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento página 57

Video
Closed
Ancillary Data
Caption Index
Timecode
Ancillary Data Menu>
Timecode
Generate
The timecode generator will generate free running output timecode appropriate for the
selected output format, even if timecode is not present on your video input signal.
‚ Set Timecode
The 'set timecode' menu options you will have are determined by the selection you
make in the 'start source' menu.
‚ Start Source = "Input"
If the 'start source' menu is set to 'input', the 'set timecode' menu will show 'input' as
the start value' for the generator. When you press the 'start' button, the generator will
capture the current input timecode value and use that value to start outputting free
running timecode. If no timecode is present on your input video source, the generator
will begin counting at 00:00:00:00.
‚ Start Source = "Start Value"
If the 'start source' menu is set to 'start value', the 'set timecode' menu will display
an eight-character register that allows the entry of a specific starting value for the
generator. Turn the rotary knob to adjust the timecode generator values and use
the 'previous' and 'next' buttons to move the cursor left or right. When you press the
'start' button the timecode generator will immediately output timecode from your
'start value' entry.
Prev Timecode Next
Off
Timecode
Start
Generator
Input
Input Regen
Set Start
Timecode Source
Generate
Jam Sync
Setup
Timecode Menu>Generate
Jam Sync
The 'jam sync' mode is similar to the 'generate' mode. However, when you press the
'start' button, 'jam sync' mode allows you to hold the output timecode generator until a
pre-determined timecode point is reached in your input video, called the 'jam sync'
value. The 'jam sync' value must be entered via the 'set timecode' menu.
Prev Timecode Next
Off
Timecode
Start
Generator
Input
Input Regen
Set Start
Timecode Source
Generate
Jam Sync
Setup
Timecode Menu>Jam Sync
Prev Timecode Next
Off
Timecode
Start
Generator
Input
Input Regen
Set Start
Timecode Source
Generate
Jam Sync
Setup
Timecode Menu>Input Regen
Prev Timecode Next
Start Value
Timecode
Start
Generator
Input
Set Start
Timecode Source
Setup
Generate>Start Source
Prev Timecode Next
Start Value
Timecode
n
Start
00:00:00:00
Generator
Set Start
Timecode Source
Setup
Set Timecode Menu. Use the
Rotary knob to set your values,
and the Previous and Next
buttons to move the cursor left
and right.
Teranex Processor Settings 57 57