Throttle Cable - Honda Motor BF40D Manual Del Usuario

5) Start the engine.
Run the engine under no load until the engine speed
stabilizes, and check the idle speed. (Idle speed inspection
1
must be made with the engine warmed up to the normal
operating temperature.)
2
Specified idle speed
(At neutral)
3
• When the idle speed is outside the specification or when
4
a symptom shown on the Idle Control System
Troubleshooting Guide appears, perform the adjustment
5
(P. 5-55).
6) After inspection, install the engine cover (P. 4-2).
6
7
8

10. THROTTLE CABLE

9
Throttle Rod Adjustment:
10
1) Remove the engine cover (P. 4-2).
11
2) Remove the remote control cable [throttle side] from the
throttle arm (P. 3-19).
12
3) Bring the throttle arm in contact with the full open stopper
A of the throttle arm bracket.
13
4) With the throttle arm in the position described in step 3,
14
measure the clearance between the throttle lever and the
full open stopper B of the throttle body. It must be 1 mm
15
(0.04 in) or below.
5) When the throttle arm does not come in contact with the
16
full open stopper A or the clearance is more than 1 mm,
adjust as follows.
17
6) Remove the throttle rod from the throttle cam.
18
Loosen the 5 mm hex nut of the throttle rod and adjust the
length of the throttle rod by turning the linkage pivot.
After adjustment, tighten the 5 mm hex nut securely.
19
7) Install the throttle rod on the throttle cam and recheck.
20
8) Install the remote control cable [throttle side] in the throttle
arm (P. 3-19).
9) Install the engine cover (P. 4-2).
3-17
850 50 min -1 (rpm)
[1]
THROTTLE
LEVER
[8] THROTTLE ARM
[4]
THROTTLE CAM
368
[2] 1 mm (0.04 in)
or below
BRACKET
[1] [2]
LINKAGE PIVOT 5 mm HEX NUT
[3]
THROTTLE ROD
[3]
THROTTLE
BODY
[4]
FULL OPEN
STOPPER B
[5]
THROTTLE
ARM
[6]
Contact.
[7]
FULL OPEN
STOPPER A