Honda Motor BF40D Manual Del Usuario página 425

4) CKP sensor 2 signal line short-circuit inspection
• Turn the combination switch OFF. Disconnect the
ECM connector A . Check for continuity between
9
the CKP sensor 2 3P connector
harness side No.1 (Green) terminal and the engine
ground.
CKP SENSOR 2 3P CONNECTOR
MAIN WIRE HARNESS SIDE
14
VIEWED FROM THE TERMINAL SIDE
Is there continuity?
YES - Repair short in the main wire harness
between the ECM and the CKP sensor 2.
NO - Go to "5) CKP sensor 2 GND line open-circuit
inspection."
5) CKP sensor 2 GND line open-circuit inspection
• Connect the ECM connector A
continuity between the CKP sensor 2 3P connector
main wire harness side No.2 (Black/Blue)
14
terminal and the engine ground.
CKP SENSOR 2 3P CONNECTOR
MAIN WIRE HARNESS SIDE
14
VIEWED FROM THE TERMINAL SIDE
Is there continuity?
YES - Go to "6) CKP sensor 2 inspection."
NO - Repair open in the main wire harness
between the ECM and the CKP sensor 2.
6) CKP sensor 2 inspection
a. Replace the CKP sensor 2 and connect the CKP
sensor 2 3P connector
b. Start the engine and check the DTC using the HDS
(Dr. H or pocket tester).
Does the DTC 8-1 appear?
YES - Replace the ECM with a new one and
recheck.
NO - End of inspection
main wire
14
CRK2 (Green)
. Check for
9
PG3 (Black/Blue)
.
14
425
DTC 8-2: Abnormal CKP sensor 2 pulse
1) Symptom reproduction test
a. Turn the combination switch OFF. Disconnect the
CKP sensor 2 3P connector
it again.
b. Clear the DTC (P. 5-12).
• Continue the procedure when the DTC does not
clear.
c. Start the engine and check the DTC using the HDS
(Dr. H or pocket tester).
Does the DTC 8-2 appear?
YES - Go to "2) Guide plate inspection."
NO - Temporary failure (Disappears.)
2) Guide plate inspection
• Inspect the guide plate.
Is the guide plate damaged?
YES - Replace the guide plate with a new one and
recheck.
NO - Go to "3) CKP sensor 2 inspection."
3) CKP sensor 2 inspection
a. Replace the CKP sensor 2 and connect the CKP
sensor 2 3P connector
b. Start the engine and check the DTC using the HDS
(Dr. H or pocket tester).
Does the DTC 8-2 appear?
YES - Replace the ECM with a new one and
recheck.
NO - End of inspection
once and connect
14
.
14
5-30