Honda Motor BF40D Manual Del Usuario página 398

• CHECK AFTER OPERATION
• Check the parts for secure installation and the bolts,
screws and other fasteners for secure tightening.
• Connect the battery cable to the battery negative (-)
terminal.
• FUEL LEAK CHECK
Turn the combination switch ON (but do not turn the
starter) after connecting the fuel lines. The fuel pump
(high pressure side) should operate for approximately 2
seconds and the fuel pressure in the high pressure side
fuel line should rise. Repeat this operation 2 or 3 times
and check for fuel leakage.
5-3
• WHEN THE BOAT IS EQUIPPED WITH RADIO
EQUIPMENT/D-GPS
The ECM and its wires are designed to be unaffected by
radio waves. However, the ECM can malfunction when it
senses an extremely powerful electric wave. Note the
following to avoid malfunction of the ECM.
• Install the antenna and the body of the radio equipment
at least 50 cm (20.0 in) away from the ECM, remote
control cable and the remote control box.
• Antenna wire must not be too long. Do not route the
antenna wire along the main wire harness and other
cables/wires.
• Do not mount high output power radio equipment on
the boat. (The maximum output power of the radio
equipment should be 10W.)
• Install the D-GPS antenna and the body unit at least 3m
away from the engine.
• Connect the D-GPS antenna ground wire to ground.
398