Honda Motor BF40D Manual Del Usuario página 760

• INTAKE MANIFOLD ASSEMBLY
1) Set the intake manifold assembly. Loosely tighten the four
6 x 32 mm flange bolts and the two 6 mm flange nuts.
2) Tighten the two 6 x 25 mm bolt/washers securely.
3) Tighten the four 6 x 32 mm flange bolts and the two 6 mm
flange nuts in several steps to the specified torque in the
numbered sequence shown.
TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft)
4) Connect the three injector 2P connectors.
5-96
[1]
6 mm FLANGE NUT (2)
6 x 32 (4)
[1]
INJECTOR 2P
CONNECTOR (3)
760
[2]
6 x 25 mm
BOLT/WASHER (2)