Honda Motor BF40D Manual Del Usuario página 744

c. INSTALLATION
1) Set the fuel line and tighten the two 6 x 32 mm flange bolts
to the specified torque.
TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft)
2) Connect the three injector 2P connectors.
3) Apply engine oil to the four new O-rings and install them
on the fuel pipe joints.
4) Set the two fuel pipe joints and install the fuel hose.
5) Tighten the two 6 x 25 mm flange bolts to the specified
torque.
TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft)
6) Install the tube clamp 7.5-11.5 on the fuel hose and connect
the drain tube to the fuel hose.
7) Install the engine cover (P. 4-2).
5-88
[1]
FUEL LINE
6 x 32 (2)
[1]
INJECTOR 2P
CONNECTOR (3)
[1]
TUBE
CLAMP
7.5-11.5
[5]
DRAIN
TUBE
[4]
FUEL HOSE
744
[2]
FUEL PIPE JOINT (2)
[3]
O-RING (4)
6 x 25 (2)