Blackmagic Design ATEM 1 M/E Manual De Instalación Y Funcionamiento página 13

Getting Started
13
BACKUP 12V POWER
USB 2.0
BACKUP 12V POWER
USB 2.0
ATEM 1 M/E Broadcast Panel rear connectors
BACKUP 12V POWER MAIN 12V POWER
USB 2.0
BACKUP 12V POWER MAIN 12V POWER
ATEM 2 M/E Broadcast Panel rear connectors
Plugging in a Broadcast Panel
If you have purchased an ATEM Broadcast Panel, then you won't want to wait to plug in your computer, as
it's much more fun to plug in the hardware panel first!
Plugging in the broadcast panel is simple, because it's already set to the correct network settings to plug
MAIN 12V POWER
ETHERNET 2 ETHERNET 1
into your switcher without any changes required.
Step 1. Plug in the power to the broadcast panel. If you want redundant power supplies, then you can
Step 2. Plug one end of an Ethernet cable into one of the broadcast panel's Ethernet ports. Either of the
MAIN 12V POWER
ETHERNET 2 ETHERNET 1
Step 3. Plug the other end of the same cable into the Ethernet port labeled Switcher Control on the
If everything is working fine, you should see the lights on the ethernet port start to flicker, and the
broadcast panel should come alive with buttons illuminated, and the main display on the panel should say
'ATEM Production Switcher'.
ETHERNET 2 ETHERNET 1
If you don't see this appear, then check that the switcher and the broadcast panel are powered correctly and
the cables are screwed in tight.
If things are still not working, then you should make sure that your broadcast panel is connected directly
USB 2.0
ETHERNET 2 ETHERNET 1
to your switcher and not via a network. If this is correct, then the most likely cause of the problem is the
broadcast panel and the switcher have IP addresses in different ranges. In this case, you will need to check
and set these as described later in this manual.
If you need to manually set the network settings, then you might need to get the assistance of a technically
minded friend who understands how to set IP addresses. By default, the switcher is set to a fixed IP address
of 192.168.10.240, and the broadcast panel is set to fixed IP of 192.168.10.10, so when connected directly
they should communicate without problem. Go to the 'Connecting to a Network' section in this manual to
see how to check and set your switcher to these addresses. Then it should work OK with a direct connection
between the broadcast panel and the switcher.
purchase a second power supply and plug that into the second power connector.
ports will do, as there is an Ethernet switch inside the panel, so both ports work the same.
switcher.