Blackmagic Design ATEM 1 M/E Manual De Instalación Y Funcionamiento página 22

Getting Started
22
Home Menu
ATEM 1 M/E Production Switcher
Control Panel Connected OK
Panel IP Address: 192.168.10.10
Connecting to 192.168.10.240...
Control Panel Not Connected
Setting the Broadcast Panel to Find the Switcher IP Location
To set the network location of the switcher on the broadcast panel, so the panel can find the switcher and
communicate, simply follow these steps:
Step 1. When there is no communication with the switcher, the NETWRK SETUP menu will appear on the
broadcast panel system control. Select the NETWRK SETUP menu button.
Step 2. Select the SWITCHR IP menu button and use the knobs or the numeric keypad to edit each field
as required.
Step 3. When a field is changed, SAVE and REVERT menu buttons become available. Select SAVE to save
the changed IP address, or REVERT to ignore the changes and revert to the currently stored IP
address.
Step 4. If the switcher IP address setting is changed, selecting SAVE will apply the changes and the
broadcast panel will attempt to establish communication with the switcher using the new IP
address.
This does not change the IP address of the switcher itself. It just changes where the control panel is looking
to find the switcher. If the control panel cannot find the switcher, then you might need to check the switcher
processor to see if it's been set correctly. To change the IP address of the switcher, connect the switcher via
USB to a computer and run the ATEM Setup Utility software as described previously in this manual.