Publicidad
Idiomas disponibles
Idiomas disponibles
Getting Started
16
Set IP Address for your Computer
Plugging in your Computer
You can plug your computer directly into the ATEM switcher so you can control the switcher, load the media
pool with graphics and clips, and change switcher settings.
You will need to connect a computer otherwise you cannot change settings such as the switcher video
standard, as well as downconversion modes, input video connections and labels, as well as customizing the
Multi View.
Connecting your computer is easy and after installing the ATEM Switcher Software simply follow the
directions below:
Step 1. Connect an Ethernet cable from the switcher ethernet port labeled Switcher Control to the
Ethernet port of your computer.
If you have a hardware panel installed, and already have this connected to your ATEM, then plug
your computer into the second ethernet port on your hardware panel instead. Now the computer
will talk via your panel to the switcher, and both the hardware panel and this software control
panel can be operated in parallel.
Step 2. Ensure your ATEM switcher is powered on.
Step 3. In the network settings on your computer, enable ethernet, and set the IP address setting to
manual. Then enter the IP address 192.168.10.50.
Now when you run your ATEM Software Control you should see the buttons on the control tab light up and
show the switcher state after a slight pause.
If you're more technically minded and want to connect your ATEM switcher to your existing network, then
you will need to change the network settings on your ATEM switcher and control panel. Information on how
to do this is available in the next section. You will need to manually set the IP address for the switcher as
well as all control panels to match your network IP address range. Your ATEM switcher defaults to a fixed
IP address of 192.168.10.240 when shipped and, by using the ATEM Setup Utility, you can customize the IP
address for your custom network configuration.
Publicidad
