Blackmagic Design ATEM 1 M/E Manual De Instalación Y Funcionamiento página 49

KEY KEY KEY KEY
1 2 3 4
LUMA CHROMA PATTRN
DVE
KEY KEY KEY
Using the ATEM 1 M/E Broadcast Panel
49
MASK
MENU
HOME
KEY KEY KEY KEY
1 2 3 4 1 2 3
4 5 6
LUMA CHROMA PATTRN DVE
KEY KEY KEY
7 8 9
MASK
MENU HOME CAM 0 CLR
CUT
FILL
Control Panel
Main
ON ON ON ON
Backup
Switcher
CUT Main
BKGD KEY 1 KEY 2 KEY 3 KEY 4 DSK 1 DSK 2
FILL TIE TIE Backup
DIP
MIX
SHIFT DSK 1 DSK 2
CUT CUT
PREV CUT AUTO DSK 1 DSK 2 FTB
TRANS AUTO AUTO
SHIFT
PREV
TRANS
Transition Control and Upstream Keyers
1 2 3
4 5 6
7 8 9
CAM 0 CLR
Transition Control and Upstream Keyers
Control Panel
Main
ON ON ON ON
Backup
CUT
Switcher
Main
DSK 1 DSK 2 The CUT button performs an immediate transition of the Program and Preview outputs, regardless of the
BKGD KEY 1 KEY 2 KEY 3 KEY 4
TIE TIE
Backup
selected transition type.
DIP
MIX
AUTO and Transition Rate
The AUTO button will perform the selected transition at the rate specified in the transition rate window.
DSK 1 DSK 2
CUT CUT
The transition rate for each transition type is set in the system control, and is displayed in the transition rate
window of the transition control block when the corresponding transition style button is selected.
DSK 1 DSK 2
CUT AUTO FTB
AUTO AUTO
The AUTO button illuminates red for the duration of the transition and the transition rate display updates to
indicate the number of frames remaining as the transition progresses. If the software control panel is active,
the virtual fader bar updates to provide visual feedback on the progress of the transition.
Fader Bar and Fader Bar Indicator
The fader bar is used as an alternative to the AUTO button and allows the operator to manually control
the transition. The fader bar Indicator next to the fader bar provides visual feedback on the progress of the
transition.
The AUTO button illuminates red for the duration of the transition and the transition rate display updates to
indicate the number of frames remaining as the transition progresses. If the software control panel is active,
the virtual fader bar updates to provide visual feedback on the progress of the transition.
Transition Type Buttons
The two transition type buttons allow the operator to select one of five types of transitions; mix, wipe, dip,
DVE, and stinger. Mix and wipe transition types are selected by pressing the appropriately labeled transition
type button.
Dip and DVE transition types are selected by holding down the SHIFT button while pressing the desired
transition type button, or by double-pressing the desired transition type button. The button will illuminate
green indicating a shifted transition type.
The stinger transition type is selected by simultaneously pressing both transition type buttons. When stinger
transitions are selected, both buttons will be illuminated green.
PREV TRANS
The PREV TRANS button enables the preview transition mode allowing the operator to verify a dip, mix,
wipe or DVE transition by performing it on the preview output using the fader bar. Once you press this
button on, you can preview your transition as many times as you like allowing you to make changes and
corrections as needed. You can even preview stinger transitions! Once you are happy with the preview
transition, press the button off and you are now ready to send your transition on air.