Blackmagic Design ATEM 1 M/E Manual De Instalación Y Funcionamiento página 91

Operating your ATEM Switcher
91
Step 2. Select the DVE menu button.
Step 3. The destination display will say key1fill on the ATEM 1 M/E Broadcast Panel. On the ATEM 2 M/E
Broadcast Panel, the KEY 1/CUT button will be lit. Select the fill source on the select bus.
Step 4. To enable the mask and adjust the mask parameters, select the MASK MENU button.
Step 5. To enable the drop shadow or border and adjust their parameters, select the BORDER menu
button. For a description of DVE borders, refer to the table below.
Adjusting the x/y position of the DVE
From the broadcast panel, the x/y position of the DVE is adjusted with the joystick.
DVE parameters
Adjusts the horizontal size of the DVE.
X Size
Y Size Adjusts the vertical size of the DVE.
Rotation Spin the box around its center point with the Rotation adjustment knob.
Resets the rotation of the DVE.
Rot Rst
DVE Rst Resets the DVE to screen. Useful if you lose track of the DVE during adjustment.
Adding DVE Borders
DVE border styles
The 3D borders used in the upstream keyers have four different style settings. The style settings adjust the
overall look of the border.
Style 1 No bevel - 2D border where the border width, softness and color adjustments are
applicable.
Style 2 Bevel in out - 3D border
Bevel out - 3D border
Style 3
Style 4 Bevel in - 3D border