Descargar Imprimir esta página

Blackmagic Design ATEM 1 M/E Manual De Instalación Y Funcionamiento página 25

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 547
Updating the Software
25
Updating the Broadcast Control Panel Software
Step 1. Connect the broadcast panel via USB to your computer. The broadcast panel is equipped with
a USB connector which can be connected to a computer's USB 2.0 or USB 3.0 port using a
USB cable.
When upgrading software, make sure the broadcast panel is the only ATEM device connected
via USB to the computer running the setup utility software. If more than one ATEM device is
connected, the panel may not be recognized.
Step 2. Launch the ATEM Setup Utility software.
Step 3. If the broadcast panel software requires updating, you will be prompted by a window asking
if you would like to update the software. Select Update Now to initiate the update process.
The update process may take a few minutes. Do not unplug power from the panel during the
software update.
Step 4. Once the software update is complete, a window will prompt you to cycle power on the broadcast
panel. Select OK and cycle power on the broadcast panel.

Publicidad

loading

Este manual también es adecuado para:

Atem 2 m/e