Publicidad
Idiomas disponibles
Idiomas disponibles
Getting Started
21
ATEM Setup Utility Connects via USB
Changing the Switcher Network Settings
The switcher network settings are changed using the ATEM Setup Utility via USB. Please follow the steps
below:
Step 1. Connect the switcher via USB, to the computer running the ATEM Setup Utility software.
Step 2. Launch the ATEM Setup Utility software.
Step 3. The switcher's current IP address and other settings will be displayed in the window. If you only
want to check the IP address and not change it, you can simply quit ATEM Setup Utility.
Step 4. To change the IP address or any other settings, simply edit the numbers and then select apply.
Step 5. A dialog box will prompt you to please power cycle your ATEM switcher. Turn off and on the
power on the switcher and then press OK.
Understanding the Broadcast Panel Network Settings
A broadcast panel's network settings are configured from the network setup menu in the broadcast panel's
system control. Along with its own IP address, the broadcast panel also needs to be configured with the
network location of the switcher, so that communication between the two devices can be established over
the ethernet connection. If the broadcast panel's network settings are correctly configured, you will see the
panel light up and buttons turn on so you can control the switcher.
If the broadcast panel is displaying a message looking for the switcher, then you will need to set the
broadcast panel's network settings so that the broadcast panel and switcher share the same subnet, and
the network location to which the broadcast panel is trying to connect, matches the switcher's IP address.
Publicidad
