Publicidad
Idiomas disponibles
Idiomas disponibles
Using Blackmagic UltraScope
130
Audio Metering Display
Audio Metering Display shows you the audio levels in the embedded audio of the SDI video signal. The 2
channels of embedded audio from your ATEM Production Switcher are de-embedded and then displayed
in either dBFS or VU format. The VU button switches between dBFS and VU audio metering standards.
dBFS is essentially a meter of the overall digital audio signal and is common on modern digital equipment.
The VU meter shows average signal levels, is easy to use and very common on older equipment. VU is
calibrated to the SMPTE recommendation of a 1 kHz tone test signal set to -20 dBFS.
The right hand audio scope can monitor two channels of audio. The audio scope presents audio in an X-Y
view so you can see audio balance issues, out of phase conditions and whether an audio track is mono or
stereo. Mono audio should appear as a single, vertical, "in phase" line. If the line is horizontal, then your
audio is "out of phase" and could cancel out (i.e. loss of audio) when received by downstream equipment.
Audio phase is one of the most common audio faults in large facilities, where cables can be incorrectly
connected.
Audio Metering Display
When monitoring stereo audio, the Audio Metering Display will puff out a little like a flower, which represents
the difference between the left and right audio channels. The more stereo sound is contained in the audio
track, the more circular the display will appear. If the audio contains minimal stereo content, then the display
will appear more concentrated around the vertical axis.
While spoken dialog tends to appear as a vertical line, music with plenty of stereo content will puff out. This
is because mono audio is L+R, and will display on the vertical axis, whereas stereo content is L-R, and will
display on the horizontal axis to show the stereo difference.
Publicidad
