Suzuki DF40A Manual Del Propietário página 28

If the overheat caution system activates when
operating, reduce engine speed immediately
and check if water is being discharged from the
pilot water hole. If no water is seen, follow the
procedures outlined below.
Water and wind conditions permitting, stop the
engine, tilt it out of the water and remove any
debris like seaweed, plastic bags or sand that
may have blocked the water intakes.
Lower the motor into the water, being sure that
water intakes are immersed, and restart it.
Check (A) that water discharges from the pilot
hole and (B) that the red TEMP lamp is no lon-
ger lit.
Be aware that the red TEMP lamp may light
again if engine temperature rises abnormally. If
either of the above situations arises, your
authorized Suzuki Marine Dealer must be con-
sulted as soon as possible.
NOTICE
Operating the engine with the overheat cau-
tion system activated can result in severe
engine damage.
If the overheat caution system activates, stop
the engine as soon as possible, wind and
water conditions permitting, and inspect the
engine according to the above instructions.
Consult your authorized Suzuki marine dealer
if you cannot correct the problem.
CHECK THERMOSTAT ALERT SYSTEM
This ALERT SYSTEM activates when the ther-
mostat breaks down and the engine tempera-
ture does not rise up to the proper temperature
after engine start-up.
Tiller handle model
If this system activates, the red TEMP lamp will
flash.
In order to cancel this ALERT SYSTEM, quickly
stop the engine and consult with SUZUKI
marine dealer.
Remote control model
25