Suzuki DF40A Manual Del Propietário página 32

"RELEASE" Position (UP)
Use this position only when you tilt the motor
up.
V WARNING
When you operate the motor with the release
lever in the "Release" position, the tilt lock
will not work. As a result, forces such as from
propeller thrust
"REVERSE" gear, rapid deceleration, and
striking an underwater object can cause the
motor to lift out of the water, resulting in per-
sonal injury.
When using the "Release" position, proceed
with caution and only at very low speed.
TILT LOCK LEVER
DF40A (QH) MODEL
The Tilt Lock Lever is provided so you can sup-
port the motor in a tilted position for non-moving
engine support.
V WARNING
If you place your hands near the mounting
bracket or under the motor when tilting it,
your hands can be crushed if the motor slips
from your grasp.
Never place your hands near the mounting
bracket or under the motor when tilting it.
during operation
To hold the motor in the fully raised position:
1. Shift into "NEUTRAL".
2. Move the release lever 1 to the "release"
position.
3. Grab the handle on the back of the motor
cover and tilt the motor all the way up.
in
If you use the throttle grip handle to raise or
lower the motor, the handle may break.
Never use the throttle grip handle to raise or
lower the motor.
If the tiller handle contacts any objects when
tilting motor up, the outboard motor or boat
could be damaged.
When tilting the motor up, position the motor
so the tiller handle will not contact such as a
tackle box, ice chest, or the motor well.
NOTICE
NOTICE
29