Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 77 Friday, April 26, 2024 11:05 AM
8
Press START. The remaining time appears in
the display.
CAUTION
• Some surfaces may be hot after the SpeedClean
cycle. Wear rubber gloves while cleaning to
prevent burns.
• During the SpeedClean cycle, the oven becomes
hot enough to cause burns. Wait until the cycle is
over before wiping the inside surface of the
oven. Failure to do so may result in burns.
• Avoid leaning or resting on the oven door glass
while cleaning the oven cavity.
9
A tone will sound at the end of the 10-minute
cycle. Press STOP in the display, and press
YES. to clear the display and end the tone.
10
After the cleaning cycle and during hand-
cleaning, enough water should remain on the
oven bottom to completely submerge all soils.
Add water if necessary. Place a towel on the
floor in front of the oven to capture any water
that may spill out during hand-cleaning.
• If you are cleaning the upper oven on a
double oven, it is also best to cover the
holes in the top of the lower oven door with
a towel to capture any water that may drip
into the door during hand-cleaning.
11
Clean the oven cavity immediately after the
SpeedClean cycle by scrubbing with a wet,
non-scratch scouring sponge or pad. (The
scouring side will not scratch the finish.)
NOTE
• Do not use any steel scouring pads, abrasive
pads or cleaners as these materials can
permanently damage the oven surface.
12
Once the oven cavity is cleaned, wipe any
excess water with a clean dry towel. Replace
racks and any other accessories.
13
If some light soils remain, repeat the above
steps, making sure to thoroughly soak the
soiled areas.
• If stubborn soils remain after multiple
SpeedClean cycles, run the Self Clean cycle.
Be sure that the oven cavity is empty of
oven racks and other accessories, and that
the oven cavity surface is dry before
running the Self Clean cycle. Consult the
Self Clean section of your owner's manual
for further details.
NOTE
• If you forget to saturate the inside of the oven
with water before starting SpeedClean, press
STOP in the display, and press YES. Wait for the
oven to cool to room temperature and then
spray or pour water into the oven and start
another SpeedClean cycle.
• The cavity gasket may be wet when the
SpeedClean cycle finishes. This is normal. Do not
clean the gasket.
• If mineral deposits remain on the oven bottom
after cleaning, use a cloth or sponge soaked in
vinegar to remove them.
• It is normal for the fan to operate during the
SpeedClean cycle.
• Using commercial oven cleaners or bleach to
clean the oven is not recommended. Instead,
use a mild liquid cleanser with a pH value below
12.7 to avoid discoloring the enamel.
Self Clean
The Self Clean cycle uses extremely hot
temperatures to clean the oven cavity. While
running the Self Clean cycle, you may notice
smoking or an odor. This is normal, especially if
the oven is heavily soiled. During Self Clean, the
kitchen should be well ventilated to minimize the
odors from cleaning.
Before Starting Self Clean
• Clean only parts listed in manual. Remove the
water tank, oven racks, broiler pan, broiler grid,
all cookware, aluminum foil or any other
material from the oven.
- If oven racks are left in the oven cavity during
the Self Clean cycle, they will discolor and
become difficult to slide in and out.
MAINTENANCE
77
Publicidad
