Ciber UACF15P1-P2 Manual De Operación página 321

MÓDULO DO CLP MÓDULO DEL CLP
(EN)
Indications of the mode of operation and PLC failures.
Indication Color
OFF
RUN
Steady
Green
OFF
Steady
FORCE
Yellow
Blinking
Yellow
OFF
BAT
Steady
Red
OFF
Steady
Green
I/O
Blinking
Green
OFF
Steady
Green
Blinking
Green
OK
Steady red
Steady
Green
Blinking
Green
08/2010 CC.15 / CC.17 / CC.19
PLC MODULE
The controller is in programming (PROG) mode or in test mode (REM).
The controller is in RUN mode (program execution mode).
There are neither forced inlets nor outlets that are enabled in the program.
There are forced inlets or outlets in the program and they are enabled.
There are forced inlets or outlets in the program, but they are not enabled.
The battery will support the memory - OK.
The battery is 95% used and should be changed.
There is no I/O module in the controller's configuration.
The controller does not have any project and its memory is empty.
The controller is communicating with all the configured I/O ports.
One or more configuration I/O ports are not responding.
There is no I/O module in the controller's configuration.
The controller does not have any project and its memory is empty.
The controller is communicating with all the configured I/O ports.
One or more configuration I/O ports are not responding.
If the controller is not new, then a more serious failure occurred but that can be recovered.
The controller detected a serious failure and the program was erased.
The controller is OK.
The controller is loading the RAM memory program.
MODULE DE L'A.P.I
Description of problem
76179/0004
02.02.02
7 / 18